On yesterday, I went to Radio Shack to pick up some jumpers to finish off the R.A.M.P.S. board. I ended up getting a few extra things for my Sells Mendel.
I found some feet for my Mendel so the hard plastic won't scratch any tables or counter tops I happen to set it down on. These feet should also help with noise reduction (I hope).
The things in the middle of the picture are 2 position barrier strips. I'm going to attach one to the underside of my heated bed so I have an easy way to connect and disconnect power from it. Two strips came in one box. I might use the second for the thermistor of the bed.
Lastly, the lovely DIP switch jumpers. Now my stepper drivers can drive 1/16th micro stepping. I haven't tried this yet because the thermal grease from attaching the heat sinks isn't sticky enough, the heat sinks come off in a strong breeze. I think I'm going to add some glue to the grease, but I need to find some high temp glue. It doesn't need to withstand 200c like some of the hot-end components, but these chips might get to ... 90c (just guessing here).